remove omp..?
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: Dec 2002
Location: wishing i was back in FL
Posts: 4,192
Likes: 0
Received 0 Likes
on
0 Posts
remove omp..?
any of you remove the oil metering pump and just run straight pre-mix? this swap is going in to my 1st gen and i hear that the omp will not fit so i am wondering if i can remove it. and ffuts.
-zac
-zac
#2
Open up! Search Warrant!
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes
on
2 Posts
you can remove it. Just need a block off plate for where the pump was and some bolts to cover the holes where the injectors went. I know one guy who used JB Weld and glued a dime over each hole.
#4
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Originally posted by Project84
I know one guy who used JB Weld and glued a dime over each hole.
I know one guy who used JB Weld and glued a dime over each hole.
For info about premix (good and bad), do a search for "premix" under my name.
Thread
Thread Starter
Forum
Replies
Last Post
Erosangel
3rd Generation Specific (1993-2002)
5
09-18-15 04:06 PM