Rear control arm bushings
 

Has anyone had any probems pressing in the rear control arms? I pressed both sides in and they went in fine but when I pressed in the metal sleeve, they both expanded out too much to bolt onto the subframe. Anyone know what is going?

There is an inner steel bushing that has to be chiselled out.

Here is a thread with pics...

https://www.rx7club.com/2nd-generation-specific-1986-1992-17/polyurethane-bushing-install-question-about-rear-bushings-607257/

No wonder they were such a pain in the ass to get in with the press. Well, I'll have to take them out and sart over. Thanks guys!