rc 750 primaries not sealing. VAC leak
#1
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Sep 2004
Location: seattle wa
Posts: 906
Likes: 0
Received 0 Likes
on
0 Posts
rc 750 primaries not sealing. VAC leak
I installed my RC Engineering 750 cc primaries and I have a horrible vac leak at the injectors. I used brand new Mazda gromits. It appears that the injectors were not being pushed into the gromits hard enough. I installed a small washer between the injector and the fuel rail to help the push the injector in to the gromit. This worked, but I still have a small leak.
Has anyone had any problems getting the RCs to seal? Has anyone found any other gromits that seal?
Thanks
Has anyone had any problems getting the RCs to seal? Has anyone found any other gromits that seal?
Thanks
#2
Rotary Freak
Join Date: May 2001
Location: Peoria, IL
Posts: 1,779
Likes: 0
Received 0 Likes
on
0 Posts
I have done three rotaries with RC cleaned injectors and Mazda factory grommets and orings. NO problems at all.
Did you clean up the mounting holes good? Sounds like maybe there is something preventing them from sealing.
Did you clean up the mounting holes good? Sounds like maybe there is something preventing them from sealing.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
alexdimen
3rd Generation Specific (1993-2002)
20
10-23-15 01:50 PM