ok, i used to have a cusco front strut tower bar, but with my intercooler piping, the bar wouldn't go on with out changing the piping. i was looking at the racing beat one and it looks like it maybe sits a little farther forward than the other strut tower bars. i was wondering if any one happens to have a pic of the racing beat strut tower bar and how it clears the alternator and that general area. a side shot would be really nice. thanks in advance.

 

Have you looked on racing beats site?

http://www.racingbeat.com/FRmazda2.htm

 

 

thanks, but i was looking for more of a dead on shot from the side, not an angled one.....and also a higher quality pic......can't tell too much there. but thanks again

 

Yo,


These are the best I got:







And I'm NA so I don't have the IC and stuff...hope that helps.


KS
1989 GTUs "No flex in a one piece bar!"

 

i'm assuming that is your car. about how close is it to the fan shroud, and about how far is it from the alternator? thanks.

 

Yo,


62mm to the fan shroud.

21mm to Alt. housing.

KS
1989 GTUs "Metric makes sense!"