Quick question for s5 tailight conversion
#1
King of the Loop
Thread Starter
Quick question for s5 tailight conversion
OK the last owner of the car ( a friend of mine) attempted to put the s5 tailights on it. The drivers side fits perfect but the passenger side sticks out. ok i read aaron cakes description and searched the forums but i still ahve 2 small questions.
1) Do i have to grind the body down on both sides or just the passenger side like shown on the AC page?
2) how much do i have to trim off each side of the s4 license plate frame to make it fit? I know i should check little by little but i have to take it elsewhere to be cut so thats not an option
Thanks in advance
1) Do i have to grind the body down on both sides or just the passenger side like shown on the AC page?
2) how much do i have to trim off each side of the s4 license plate frame to make it fit? I know i should check little by little but i have to take it elsewhere to be cut so thats not an option
Thanks in advance
#6
King of the Loop
Thread Starter
OK ill guess ill just try to meassure it and hope it fits. I Assumed it was just the passnger side because my drivers side sits fine, just the pasenger side sticks out. Thanks anyway guys
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM