Quick Question with pictures.
#1
Full Member
Thread Starter
Join Date: Jun 2003
Location: Illinois
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Quick Question with pictures.
I'm installing +2 option to my car and i can't figure out where this goes. Did i not get all the pieces that i need to install this? or do i have to take off the upholstery in front of the speaker towers?
#4
24 yrs driving 2nd Gen RX
Join Date: May 2002
Location: A Mile Closer to God (Denver)
Posts: 525
Likes: 0
Received 0 Likes
on
0 Posts
Craig,
I can't quite make out what's in the picture, but I just converted my '87 TII to a +2 which I removed from an '88 GXL.
Based on your question about the carpet over the rear speaker towrers, I am guessing that you're unclear about the latches which hold the seat back up.
There are two "hooks" which bolt onto the rear speaker towers, and you have to have the molded upholstery which will accomodate them.
Also, there are a pair of hing bases which bolt onto the body and allow the seat back to rotate from up to down position.
If you'd like, I can send you some pictures of my conversion. Drop me a line at kbkoop@comcast.net and let me know what (beside the obvious) you'd like to see.
- k -
I can't quite make out what's in the picture, but I just converted my '87 TII to a +2 which I removed from an '88 GXL.
Based on your question about the carpet over the rear speaker towrers, I am guessing that you're unclear about the latches which hold the seat back up.
There are two "hooks" which bolt onto the rear speaker towers, and you have to have the molded upholstery which will accomodate them.
Also, there are a pair of hing bases which bolt onto the body and allow the seat back to rotate from up to down position.
If you'd like, I can send you some pictures of my conversion. Drop me a line at kbkoop@comcast.net and let me know what (beside the obvious) you'd like to see.
- k -
#5
Full Member
Thread Starter
Join Date: Jun 2003
Location: Illinois
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
thanks a lot. i didn't want to have to remove all of the upholstry and trim stuff to get to the rear speaker towers if i was just missing something. thanks
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM