Quick F.I. Cleaner Question
Quick F.I. Cleaner Question
The reason I need to run F.I. cleaner is because the car is very sloppy before 4k rpms and very annoying and difficult to drive. I assume as long as the car is cruising anywhere below 4k rpms it will clean the primary injectors? If that is the case ...can the car be static and in nuetral while I have the motor rev'd up into cruising rpms?
I really don't have anywhere to go and I will not drive the car anywhere in its condition ...so that being the case ...is my suggestion still as effective as if the car was normally cruising?
I really don't have anywhere to go and I will not drive the car anywhere in its condition ...so that being the case ...is my suggestion still as effective as if the car was normally cruising?
If you really want the injectors clean then pull them and have them ultrasonicaly cleaned. If you are cheap and want them clean you can buy the 3M cleaning kit that connects to the fuel rail. If you're really cheap you can pull the injectos and clean them like this guy.
http://www.slantsix.org/articles/dib...conversion.htm
Scroll 1/2 way down.
Driving the car or running the car in the driveway with injector cleaner in the tank may help, but it's nothing like running the cleaner full strength through the injectors.
http://www.slantsix.org/articles/dib...conversion.htm
Scroll 1/2 way down.
Driving the car or running the car in the driveway with injector cleaner in the tank may help, but it's nothing like running the cleaner full strength through the injectors.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
Oct 9, 2015 10:05 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM
ray green
1st Gen General Discussion
2
Sep 2, 2015 06:35 AM



