Hey, so heres the deal... I got a set of rear seats for my car (originally didnt have them) and I cant figure out how to install them!
What I cant figure out is on the back half of the seat... the part that folds down... it has the pivot points, or at least holes for it to pivot on, but I cant seem to find anything that it is supposed to connect to.
Second, the half that you sit on, it has two hoops on the back of it that stick out towards the back of the car... what are these for?
And where do the seat belts attach to?
I just took pictures of what Im talkin aboot but they are too large to attach... Ill see what I can do.
Any help would be great, thanks

Snuffs

 

Pivot Hole...

 

brain fart... loop pic wont upload...

 

to the top

 

bump

 

Ya damn canadians, aboot aboot! There should be holes under the storage bins for the seat belts/etc. I don't recall that 'pivot' being used for anything that I can remember. Got a picture of those hoops? could be the latches for the seat (go through the strut tower)

 

Pic of the loop which is located on the half of the seat that you sit on, not the part that your back is against... These are not the loops that connect to the strut towers, I have those already. Just wondering what these are for?
Also if anyone can tell me how the BOTTOM of the half of the seat that your back is against gets fastened to the car that would be great.
Thanks

 

bummmmmmmp

 

I believe those sort of slid up inside the top peice of the seat on mine, I don't remember anything else about them.

 

Bump... anyone else that has rear seat care to comment?
Thanks