Question for thoes who have dissasembled a trans
#1
Learned alot | Alot to go
Thread Starter
iTrader: (2)
Join Date: Apr 2002
Location: Rotaryland, New Hampshire
Posts: 4,232
Likes: 0
Received 0 Likes
on
0 Posts
Question for thoes who have dissasembled a trans
How did you get the trans case to seperate from the intermediate housing? Do i have to buy the mainshaft pusher? How much force does it take to press the shaft though?
#4
Senior Member
Join Date: May 2006
Location: Northern california
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
nope, i recently did this. first you need to read the fsm on removing the trans.
the real trick is getting the shift lever out of the way.
then get a rubber hammer and flat screw driver and hit the end of the tranny to seperate.
just gota tap around the seals to loosen them up.
but first look at this
http://www.teamfc3s.org/main/factory...ANSMISSION.pdf
on page 8
i will help you along the way if needed
oh and you need to remove the big C clip on the main shaft
(i have pics too)
the real trick is getting the shift lever out of the way.
then get a rubber hammer and flat screw driver and hit the end of the tranny to seperate.
just gota tap around the seals to loosen them up.
but first look at this
http://www.teamfc3s.org/main/factory...ANSMISSION.pdf
on page 8
i will help you along the way if needed
oh and you need to remove the big C clip on the main shaft
(i have pics too)
#5
MazdaTruckin.com Founder
Join Date: Mar 2003
Location: East Charlotte, NC
Posts: 402
Likes: 0
Received 0 Likes
on
0 Posts
Although not exactly what your looking for this might help a little:
Mazda Transmission Modification
Mazda Transmission Modification
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM