ok, i spend the past hour or two looking for bolts the right size to replace the oil injectiors, i was wanting to know, can i just leave the injectors in and just cap the ends with a vacume cap?

 

M10x1.25 I am almost positive thats the size.

you can usualy find them at the autostore, usualy have to hit up more than one autostore to round up all 4, and then you have to cut them to length. Use one copper washer under the bolt.

 

i was wanting to avoid cutting them, but finding m10x1.25 by 10mm is near impossable

 

Where are you looking? I know I have seen M10x1.25 at Home depot, if they are too long for you, cut them down to lenght. Or try a bolt supply place, they have everything!

 

i got mine down the street at lowe's. 2 of them were short enough but the other 2 i just shaved to length with a dremel.

 

Mine aren't short enough and I didn't want to cut them either. What I did was put them in partially and seal it up with rtv. Pretty much just pur rtv around all the threading and screw them in partially. I got mine at OSH..

 

When you plate off the OMP, do you have to worry about cutting a small groove in the ousing so there isn't wierd pressure problems? I seem to remember that this had to be done when people switched the RA pre-mix injection.