Problem: Wolf 3D system not working
Passenger
Posts: n/a
Problem: Wolf 3D system not working
Hope you all can help. I recently installed a Wolf 3D system into my 90 rx7, and the problem is, it won't start, only sputter a little and that is all. Is there anyone here with experience with this system, as I am at the end of my rope and soon to tie a noose onto it.
Thanks,
Mike
Thanks,
Mike
Senior Member
Joined: Mar 2001
Posts: 482
Likes: 0
From: St. Pete, FL
Hi,
There is a new wolf forum out there, at the address at the bottom of the e-mail. Another guy is having issues also. I posted a reply to him there.
Things to look for:
Getting RPM while cranking?
Did you make sure you installed the crank trigger correctly? 60' BTDC when dropped in? Did you set cranking timing to 0' and hit it with a timing light to make sure it is at 0?
Is the gap set correctly with the crank trigger? minimum of .001?
Are you getting errors while cranking in the datalogging section for Sig Err?
When cranking did you add cranking fuel rate till it started?
Is the total scale set correctly as listed with the chart in the manual?
Dip Switches set correctly?
Hope these help some..
Scott
There is a new wolf forum out there, at the address at the bottom of the e-mail. Another guy is having issues also. I posted a reply to him there.
Things to look for:
Getting RPM while cranking?
Did you make sure you installed the crank trigger correctly? 60' BTDC when dropped in? Did you set cranking timing to 0' and hit it with a timing light to make sure it is at 0?
Is the gap set correctly with the crank trigger? minimum of .001?
Are you getting errors while cranking in the datalogging section for Sig Err?
When cranking did you add cranking fuel rate till it started?
Is the total scale set correctly as listed with the chart in the manual?
Dip Switches set correctly?
Hope these help some..
Scott
Thread
Thread Starter
Forum
Replies
Last Post
