problem or not?
Thread Starter
oops......speed bump....
Joined: Oct 2003
Posts: 390
Likes: 0
From: los angeles
problem or not?
when I start my car it rews up to 3.000rpms and then when it warms up it drops bellow 1.000 and it maintains like that. It doesn`t go up nor down.
Is bellow 1.000 rpms bad for the rotaries or not(when in neutral).
thanx
Is bellow 1.000 rpms bad for the rotaries or not(when in neutral).
thanx
T2 Noob.
Joined: Jun 2003
Posts: 1,083
Likes: 0
From: San Fran-Mateo
If I were you I would eliminate AWS (the thing that makes your car go up to 3k upon startup) since high revs like that is especially bad on a cold motor. Mazda had this feature simply to warm up the pre-cat to make it more emissions friendly at the expense of your motor.
Thread Starter
oops......speed bump....
Joined: Oct 2003
Posts: 390
Likes: 0
From: los angeles
Originally posted by fc3seeker
If I were you I would eliminate AWS (the thing that makes your car go up to 3k upon startup) since high revs like that is especially bad on a cold motor. Mazda had this feature simply to warm up the pre-cat to make it more emissions friendly at the expense of your motor.
If I were you I would eliminate AWS (the thing that makes your car go up to 3k upon startup) since high revs like that is especially bad on a cold motor. Mazda had this feature simply to warm up the pre-cat to make it more emissions friendly at the expense of your motor.
is it pain in the butt to take it off?
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM