hey guys i am installing power door locks and i opened up the door cover and noticed about 6 groups of wires that are terminated, is there a way i can connect my power door lock kit to an exsisting wiring in the car. none of the groups of wires go to anything.

 

i looked through the fsm and really couldnt find much info.. i found out that the car is prewired for power locks but it leavs me with no idea where the wires lead to. can any one help me out with this installation?!

 

The stock power lock is a follow me system. It uses a switch in the drivers door to activate a motor in the passengers door.

If you have a base or non power window FC, then you could use the extra wires for your aftermarket power door locks

 

so there is no centeral controll unit in the factory power locks?

 

lock... not locks.

Again the stock power lock system on the RX-7 (regardless of generation) only has a power door lock motor in the passengers door. No power door lock in the drivers door.

So when you lock the drivers door with the key or with the latch switch (inside latch) then it sends a signal to the lock the passengers door.

So even if you had the factory power door lock, you would need to wire in relays and mount a power door lock motor into he drivers door for any sort of keyless entry or power door lock system.

 

hmm ok kwel thanks for the responce... i can use some of the wiring then but i will have to add more through the door...
will post picks and possiably a write up once done.

 

? ever happend with your install