Parts needed:tps, maf, bac valve
#1
Full Member
Thread Starter
Join Date: Mar 2003
Location: CA
Posts: 152
Likes: 0
Received 0 Likes
on
0 Posts
Parts needed:tps, maf, bac valve
hey, is there anyone out there who is selling a tps, maf (air flow meter), and a bac valve for a 91 rx7 na.
Also, i just rebuilt my motor and i cant get it to idle. its got good compression, spark, fuel. i can start it up (with a little bit of trouble but it starts) but once it starts up ots runs for a few secs and then stalls out. the only way i can keep it running is if i keep my foot on the gas. does anyone have any idea of whats wrong ? thanks
Also, i just rebuilt my motor and i cant get it to idle. its got good compression, spark, fuel. i can start it up (with a little bit of trouble but it starts) but once it starts up ots runs for a few secs and then stalls out. the only way i can keep it running is if i keep my foot on the gas. does anyone have any idea of whats wrong ? thanks
#2
#3
Full Member
Join Date: Feb 2003
Location: Austin, TX
Posts: 143
Likes: 0
Received 0 Likes
on
0 Posts
Adjust idle on the BAC, the throttle stop screw and/or the throttle cable. After putting in a Walbro and TB mod, I had to adjust the throttle stop screw to keep it from dying.
#4
Full Member
Thread Starter
Join Date: Mar 2003
Location: CA
Posts: 152
Likes: 0
Received 0 Likes
on
0 Posts
thanks but i already tried to juice up the idle by using the screw and even adjusted the accel. cable back further but it still dont idle. the three things i need will definetly mess with the idling problem right? also i just found out that when i choke off the smog pump nothing happens.( when i used to do that before the rebuild it would stall out almost immediately)now its the same. i keep a pole on the pedal to keep it running.i did a crude tps test, by having it running(at like 2k rpm) and pressed on the the dual tps.nothing happens. does that means its dead? thanks for the replies.
Thread
Thread Starter
Forum
Replies
Last Post