i hope someone can help with this scenario. i have an 87 gxl i have swapped the tranny with a low milage turbo II one. i fill up the tranny with redline mt-90 after installing it and go to install the driveshaft and the tranny will not spin. so i install the shifter and try shifting gears and in goes into 1st and 2nd smoothly but will not go into any other gear. here's the breakdown, new act clutch flywheel combo, new pilot, new release, new clutch slave, master, and stainless steel hose (bled correctly and pedal is very stiff). checked the shifter surround for debris or pieces of old shifter bushings. and found nothing, also cleaned out the shifter surround. any other ideas on what this could be ?

 

fricki-fricki
bump stiggidy bump

 

are you using the t2 driveshaft, flywheel,clutch and starter???

 

i am using all tII hydraulics, flywheel, clutch, bearings, starter, and an n/a auto driveshaft (temporary until i get my tII rear end halfshafts) with n/a lsd. also using redline mt-90 oil.