Ok im about to rewire my fuel pump in prep for my turbo swap and im just a little comfused. Do i run the new + and - wire directly to the fuel pump it self or do i run it to the harness outside of the fuel tank on the fuel pump mounting door/plate?

 

Run it to the harness. The thickness of the stock harness wire is adequate for even a large pump, and it's a bit of a pain to seal the wires safely where they enter the fuel tank.

 

Ya that what i was trying was confused about. How to seal the wires if i ran them to the pump. So why in the 1300cc write it does it tell you to take out the fuel pump? Just to clean it and check if its ok?

 

I've never seen the 1300CC writeup....Just looked it up and yes, they say to just clean it.

 

ok thanx