OMP block off step by step
#1
Full Member
Thread Starter
Join Date: Jun 2004
Location: jersey
Posts: 97
Likes: 0
Received 0 Likes
on
0 Posts
OMP block off step by step
is there any step by step for this also does anyone sell the block off plates(mind you i pick up my rex tommorow i want to be prepared)
#2
remove intake manifold.
remove vacuum spider, associated vacuum lines.
take pliers or vice grips, around the top barbs of the oil injectors. twist and unscrew them.
use some rtv, and 10x1.25 bolts or is it 10x1.00.? bring in the injectors to match up thread size. i ended up getting 3 different thread types from napa to find one matched the housing threads. make sure they are not longer than an inch. less is a little better...you dont want them going into the housings too far ...use the old copper washer from the injectors to also help seal.
cap the big vacuum nipple on back of UIM.
remove omp and linkage rod. get custom or k2rd blockoff plate. i used 3 dimes, yes dimes (fits perfect) to block the circle hole under omp that the shaft is housed in... from falling out, then sealed with rtv and k2rd blockoff plate.
then use tcw-3 certified premix only, in your gas tank. some say 1oz/gallon, others say its too rich, find whats best for you.
remove vacuum spider, associated vacuum lines.
take pliers or vice grips, around the top barbs of the oil injectors. twist and unscrew them.
use some rtv, and 10x1.25 bolts or is it 10x1.00.? bring in the injectors to match up thread size. i ended up getting 3 different thread types from napa to find one matched the housing threads. make sure they are not longer than an inch. less is a little better...you dont want them going into the housings too far ...use the old copper washer from the injectors to also help seal.
cap the big vacuum nipple on back of UIM.
remove omp and linkage rod. get custom or k2rd blockoff plate. i used 3 dimes, yes dimes (fits perfect) to block the circle hole under omp that the shaft is housed in... from falling out, then sealed with rtv and k2rd blockoff plate.
then use tcw-3 certified premix only, in your gas tank. some say 1oz/gallon, others say its too rich, find whats best for you.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM