Notes on converting to LED lighting-incomplete
#26
Rotary Enthusiast
Thread Starter
Nope, the sunroof buttons are not lit. I thought it would be nice to have the buttons lit. I cut some clear plastic that I scavenged from a model kit and kit to fit the holes. I went through 2 or 3 pieces before I got one to fit the button.
#28
Rotary Enthusiast
Thread Starter
I ran a wire down to the dashboard, and tapped into the gauge harness. On the white plug, it's a red wire with a green stripe. I mention all this in my write-up. Once again, I'm just down to finishing the instrument cluster and I'm done.
Meanwhile, I found that my brake master cylinder switch is bad. It's not fully disengaging, which causes the brake lamp to stay lit. The fluid level is fine. Looks like I'm going to replace the master cylinder when I redo the brakes after all.
Meanwhile, I found that my brake master cylinder switch is bad. It's not fully disengaging, which causes the brake lamp to stay lit. The fluid level is fine. Looks like I'm going to replace the master cylinder when I redo the brakes after all.
Thread
Thread Starter
Forum
Replies
Last Post