No volts to EGI fuse & fuel pump
#1
Full Member
Thread Starter
Join Date: Jan 2002
Location: Port Orchard, Washington
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
No volts to EGI fuse & fuel pump
I just installed a j-spec engine and swapped wire harneses. The engine won't start and I thought it might be the injecton(did low impedance resistor pack jumpering for high impedance injectors), but come to find out the fuel pump is not running. replaced fuel pump with new one,but still nothing.
Checked voltage at plug near fuel pump and am not getting voltage to pump(black wire) I am getting volts to fuel guage.
Checked EGI fuse and its good, but am not getting voltage to fuse at fuse block left hand side engine compartment.
Checked main relay(left side of engine compartment) as per shop manual and its working.
Tried jumpering yellow test plug for fuel pump as per manual and still nothing.
Have not hooked up wiring to manual trans(does that make any difference? manual doesn't say one way or another)
Checked voltage at plug near fuel pump and am not getting voltage to pump(black wire) I am getting volts to fuel guage.
Checked EGI fuse and its good, but am not getting voltage to fuse at fuse block left hand side engine compartment.
Checked main relay(left side of engine compartment) as per shop manual and its working.
Tried jumpering yellow test plug for fuel pump as per manual and still nothing.
Have not hooked up wiring to manual trans(does that make any difference? manual doesn't say one way or another)
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
LunchboxSA22
2nd Generation Specific (1986-1992)
37
10-26-15 10:53 AM
ChrisRX8PR
Single Turbo RX-7's
21
10-18-15 04:01 PM