No Heat
#1
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Grafton WV
Posts: 301
Likes: 0
Received 0 Likes
on
0 Posts
No Heat
Well i haven't paid much attention to it cause I've been trying to get more important things straighten out but the heater in my 87 t2 dont work. i switched the controls and the little black box with the controls with my old rx7 cause i knew they worked but still no heat. only thing i didn't switch cause i couldn't unplug it is the chip board that everything plugs into (controls and that black box) What else could it be whats usally the first thing to go that would cause no heat? everything else works.
#3
Former Moderator. RIP Icemark.
A couple of times I have seen the air mix motor plug come loose after someone has been working in the dash. Might check to see it that is the case with yours.
#4
Full Member
Join Date: Nov 2001
Location: Prince George , British Columbia, Canada
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
I also think it may have come unpluged. This as well happened to me. I had to pull out my dash to get to the connection. What a pain in the _ss.
Good luck (hopefully it's someting a bit more simple)
Kerry
Good luck (hopefully it's someting a bit more simple)
Kerry
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM