New Guy
#1
Junior Member
Thread Starter
Join Date: Nov 2007
Location: Ewa Beach, Hi
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
New Guy
im new to the RX7's but been a big fan of them since the 1stGen. I just picked up a 2gen JDM 13BT series 5. It already got some stuff done to it (exhaust,upgraded top mount) but i would like to get the most power out of it. What should my steps be to have a Safe/powerful/ reliable motor? looking to spend about 5-8k
#6
Junior Member
Thread Starter
Join Date: Nov 2007
Location: Ewa Beach, Hi
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
thanks, learned alot in the past couple of days. Picking up the car next week. Gota install the Oil lines, and wire harness, then i am off. I think i might go with the 3mm seal from the start since i have my Evo to drive. Then take on the suspension/roll cage and start AutoX to get use to this setup and then make power improvements from there.
Thread
Thread Starter
Forum
Replies
Last Post
Kruel13
1st Generation Specific (1979-1985)
24
09-16-15 09:08 AM