The title says it all. In a previos post regarding the auto to manual swap a lister states that the trans crossmember mounts can be purchased from mazda for around 40 dollars. What I am talking about here are the actual sheetmetal "ears" that must be welded into the unit body inside the trans tunnel. They are for an S5 Manual trans car, they will be used to acomplish a stock like conversion from auto to manual.

I did call 2 mazda dealers and they stated that if I can get them a PN then they can be ordered and are most likley warehoused in LA, but both also said they didn't have any way to look up a PN.

If need be I will buy a battery powered sawzall and cut them out of a junk yard car, but if I can get them with much less trouble for under 50 dollars I will go for it.

If your in the know, please help.

 

I'm havin the same problem. I went out and bought a jig saw today to get them out of scrapped car. I did the swap two years ago and have been using a fabricated crossmember but now I'm doing a turbo II swap so I want to do it right this time. I f you get those part numbers let me know.

 

BlackDragonAuto.com sells the transmission crossmembers as part numbers 62-675, 62-677, 62-676, 62-678 depending on year and NA or TII. Pries are $100 for the S4 N/A and $80 for the rest.

They sell the "Trans Mount Bracket" which looks like what you want, for $22 as PN 62-685 and 62-686.

You can probably get a catalog at BlackDragonAuto.com.

 

just finding the spotwelds on it isnt fun............

 

the "ears" on the body come with the whole floor pan, basically if they had it it would be $1000

the crossmember is the bolt in part that goes across the bottom, they are different s4 s5, t2 and na, and i think mt or at

there is also the Y bit

and the 2 rubbers for the side of the Y

 

those things are spot-welded into the floorpan
if they have it, it would NOT be 1000.