need help pease
#1
Full Member
Thread Starter
Join Date: Apr 2001
Location: pittsburgh, pa, usa
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
need help pease
ok, where should i start. i had to buy front rotors and pads so i could pass inspection. well, i went to replace the driver side rotor and everything was going fine until it was time to get the old fu$&*^%(^ rotor off. this took me 2 hours to do with a sledge hammer and PB blaster. so then i thought here we go , im almost finished until i discovered the the reject who owned the car before me must of broke the pins that go through the caliper that hold the brake pads in place. well, i tried for 2 more hours to get these pins that he rigged in there out and i couldn't budge them. look at the other side and only one of the original pins are in that side. so my next step is to cut them out. now here is my major question, Where can i get the original pins at???????? look at mazdatrix website and they dont list them nowhere. can someone please help me?
thanks in advance
thanks in advance
#3
Junior Member
Join Date: Aug 2001
Location: Southampton, England
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by z-man
by the way, its an 86 N/A with 4 piston calipers
by the way, its an 86 N/A with 4 piston calipers
#4
Former Moderator. RIP Icemark.
Originally posted by ralph f cooke
I may be wrong but I don't think the 4 piston calipers were originally fitted to the N/A models that far back.
I may be wrong but I don't think the 4 piston calipers were originally fitted to the N/A models that far back.
Thread
Thread Starter
Forum
Replies
Last Post
juanrotores
Time Slips and Dyno
1
08-16-12 01:02 PM