Need help on my new 1986 maxda rx7
#1
Junior Member
Thread Starter
Join Date: Jun 2008
Location: philadelphia
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Need help on my new 1986 maxda rx7
im new to the JDM world and RX7 world. My main problem is that my RX7 is not kicking over for me at all. I have spark from sprak plugs and its trying to kick over but it just wont. What do you think the problem could be. Im in need of any opinions or what i should check. Thanks everyone.
#3
Senior Member
iTrader: (2)
Join Date: Mar 2004
Location: Charlottesville, VA
Posts: 690
Likes: 0
Received 0 Likes
on
0 Posts
You might also want to verify that the Crank Angle Sensor is set correctly. This would trash your timing and the engine would never start. Check the FSM for the procedure on accomplishing this task, or run a search on stabbing the CAS.
#4
Rotary Freak
Join Date: May 2001
Location: Peoria, IL
Posts: 1,779
Likes: 0
Received 0 Likes
on
0 Posts
I wouldn't worry about the CAS yet, maybe later. But, unless you have messed with the timing, it won't go out by itself.
I would pull the plugs and see if they are dry or wet.
If dry, try spraying some starting fluid in to the intake and see what happens. If it starts for just a second or two, you have a no fuel problem.
If wet, search "flooding" and try the unflooding procedure.
I would pull the plugs and see if they are dry or wet.
If dry, try spraying some starting fluid in to the intake and see what happens. If it starts for just a second or two, you have a no fuel problem.
If wet, search "flooding" and try the unflooding procedure.
Thread
Thread Starter
Forum
Replies
Last Post
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM