2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Need help identifying a piece and bad idle

Thread Tools
 
Search this Thread
 
Old Mar 19, 2009 | 02:52 PM
  #1  
Andrizzanizz's Avatar
Thread Starter
Rotary Freak
Tenured Member 10 Years
iTrader: (1)
 
Joined: Jun 2007
Posts: 1,554
Likes: 0
From: Charleston, SC
Need help identifying a piece and bad idle

So my 10thae has been a pain in my *** the whole time ive had it.
Now i had it running right and the intercooler popped off so while i was putting it back in i broke a piece, i dont have a working camera so ill circle it on a picture i found. idk what that piece is but when i broke it the car was still running fine.
then i let it sit for a while, i came back and now it wont hold an idle.
any ideas? does this part affect it?
Attached Thumbnails Need help identifying a piece and bad idle-tii-engine-bay.jpg  
Reply
Old Mar 19, 2009 | 04:29 PM
  #2  
RotaryRocket88's Avatar
Top Down, Boost Up
Tenured Member 10 Years
iTrader: (7)
 
Joined: Mar 2008
Posts: 8,718
Likes: 6
From: San Diego, CA
The AWS valve. Your idle sucks now because there's a big vacuum leak. Remove the broken valve & seal off the openings on the intercooler and the UIM.
Reply
Old Mar 19, 2009 | 07:58 PM
  #3  
Andrizzanizz's Avatar
Thread Starter
Rotary Freak
Tenured Member 10 Years
iTrader: (1)
 
Joined: Jun 2007
Posts: 1,554
Likes: 0
From: Charleston, SC
the aws valve has two wires runnin to it though, does it matter if i just unclip the harness that they are connected to?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
Microtech
30
Apr 23, 2016 06:37 PM
imitek
3rd Generation Specific (1993-2002)
9
Aug 28, 2015 05:28 PM
Kruel13
1st Generation Specific (1979-1985)
10
Aug 26, 2015 12:17 PM




All times are GMT -5. The time now is 04:05 AM.