Need Help Fly Wheel
Thread Starter
Joined: Apr 2006
Posts: 799
Likes: 0
From: Los Angeles
Need Help Fly Wheel
need help taking off fly wheel took of the 3 bolts and the big middle big one, tried hammering, prying, WD40, putting screws in it no use any suggestion THANK
the 3 bolts? 
anyway, if you've pulled the 54mm bolt, then get a 2x4 plank and lay it across the flywheel. hold it firmly in place and give it whack or two in the center with a hammer. that should do it.
anyway, if you've pulled the 54mm bolt, then get a 2x4 plank and lay it across the flywheel. hold it firmly in place and give it whack or two in the center with a hammer. that should do it.
Winter sucks
Joined: Jan 2004
Posts: 3,083
Likes: 0
From: Newberg, Oregon
Yeah... wtf 3 bolts? If you are referring to the pressure plate bolts... there's usually 6.. 
And if you have gotten the big 54mm one, just keep hitting it! Throw some PB Blast on there, let it sit... then come back with anger.
And if you have gotten the big 54mm one, just keep hitting it! Throw some PB Blast on there, let it sit... then come back with anger.
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
Have you tried reading the flywheel topics listed in the FAQ? This has been covered many times and there is only one method that works 100% of the time.
While prying on the back of the flywheel with a prybar (this takes two people usually), strike the face with a largish hammer near the outer edge. If you are worried about damaging the flywheel then put a bit of metal between the flywheel and the hammer.
While prying on the back of the flywheel with a prybar (this takes two people usually), strike the face with a largish hammer near the outer edge. If you are worried about damaging the flywheel then put a bit of metal between the flywheel and the hammer.
Thread
Thread Starter
Forum
Replies
Last Post
rx7jocke
Suspension/Wheels/Tires/Brakes
72
Jun 17, 2016 03:48 AM