Today i was replacing my salve cylinder because my cluctch pedal jsut went right to the floor now i have the new one in the clucth pedal is nice and hard but if i push it down all the way its sticks what could be wrong and know my car wont start do u think i flood the engine because i turn i on and off a couple of times tahtnks

 

to fix teh clutch pedal just get down there and grab it and pump it until it will return on it's own, might take a while and will probaly work faster if the car is running, assumeing you got it started

 

but the boot on the slave it gets pumped with air and gets bigger and bigger

 

did you bleed all of the air out of the system when you replaced the slave? sounds like you did if the peddle was hard, but it shouldn't stick down...are you sure the seals inside the slave are installed correctly?

 

the boot and the rod came unassembly how should i install them i think i did it right
Thanks
Pierre

 

it should work then...I don't understand this "boot on the slave getting pumped with air". That shouldn't happen...It's not getting fluid in the boot?