Need Help
#1
Full Member
Thread Starter
Join Date: Nov 2003
Location: 808 State
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
Need Help
I have a 86 RX7 and im installing my RB Headers and I dont have 1 bolt out of the 4 thats for the headers and i dont have 4 of the nuts, anybody know the sizes????? And do i need to buy a koyo radiator cap??or could i just get any type of radiator cap to fit it??
#2
Seduced by the DARK SIDE
Join Date: Apr 2001
Location: Orange Park FL (near Jax)
Posts: 7,323
Likes: 0
Received 2 Likes
on
2 Posts
I just took one of the nuts to the parts store & matched up the threads.
I ended up using 3 studs & nuts with 1 bolt.
There is a quality difference in caps. I once had a Stant cap the blocked drawback from the overflow jug.
I ended up using 3 studs & nuts with 1 bolt.
There is a quality difference in caps. I once had a Stant cap the blocked drawback from the overflow jug.
#5
Rotary Enthusiast
iTrader: (9)
Join Date: Jun 2003
Location: west
Posts: 1,191
Likes: 0
Received 0 Likes
on
0 Posts
O2 sensors are all the same except the connectors.
The S4 and S5should be the same connector . The thread is the same with almost all O2 sensors. If the old one has many miles on it, get a universal one from Checkers. They're like $30 or so.
The S4 and S5should be the same connector . The thread is the same with almost all O2 sensors. If the old one has many miles on it, get a universal one from Checkers. They're like $30 or so.
#6
Moderator
iTrader: (1)
The O2 Sensors are Interchangable with the exception of the connector. Both series O2 Sensors have different Harness Plugs but either than that, they are essentially the same. It can easily be corrected by swapping the respective Harness Plugs.
Be sure to solder, heatshrink wrap and possibly wrap the connections with Electrical Tape, should you go follow this route.
Be sure to solder, heatshrink wrap and possibly wrap the connections with Electrical Tape, should you go follow this route.