swapping n/a to TII . I will be useing the turbo tranny and drive line , but I'm keeping the 88 gtu rear end in it. Can i use a turbo pinion flange on my n/a rear end? I know i could re drill the holes in n/a flange but then there is the hole balance thing , and yes i did a search so any input would be great thanks Corbit

 

hum nobody knows this , Well I'm going to try to make it work i'll post up if it does

 

i just bored the holes out on the drive shaft. then bolts right up

 

I don't think the t2 unit will fit in there. Its an extra inch in diameter...