my exhaust setup pictures. 3' turboback
#1
Senior Member
Thread Starter
my exhaust setup pictures. 3' turboback
i got bored, had a digicam, and had the whole exhaust off the car. ive had a bunch of questions about this. so i figured i would post some pictures of what it looks like. i love the sound of the exhaust, very deep throaty tone, it will vibrate your insides at a gas station or overpass. and i contribute that to the RB presilencer.
its a 3' racing beat dowpipe, and presilencer, coupled to a 3' corksport catback. it was a little tricky getting it to fit because the presilencer wants to exit out the pass side, and the corksport is made to go out the drivers side.
-D
-edit: the bung on the presilencer i put on there for my WBo2, and the extra cuts on the catback where it attaches to the presilencer is because the CS tapers down to 2.5' to bolt to the stock cat, i had to get a 3' flange and weld it on.
its a 3' racing beat dowpipe, and presilencer, coupled to a 3' corksport catback. it was a little tricky getting it to fit because the presilencer wants to exit out the pass side, and the corksport is made to go out the drivers side.
-D
-edit: the bung on the presilencer i put on there for my WBo2, and the extra cuts on the catback where it attaches to the presilencer is because the CS tapers down to 2.5' to bolt to the stock cat, i had to get a 3' flange and weld it on.
Last edited by bejbis; 12-08-03 at 05:53 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM