Most efficient way to plug up the rear water nipple of the rear plate after TB Mod.
#1
Most efficient way to plug up the rear water nipple of the rear plate after TB Mod.
I currently have a hose running of the rear plate to the water pump housing. I did this to bypass my former cold start setup. The water pump housing Is coming out yet again so I could have that tig welded.
As for the water nipple, off the rear plate, what was done to plug It up. I'm looking for Ideas here. I will be doing this Insync with my Koyo Rad Install.
As for the water nipple, off the rear plate, what was done to plug It up. I'm looking for Ideas here. I will be doing this Insync with my Koyo Rad Install.
#2
Rotary Motoring
iTrader: (9)
I tapped the waterpump housing for a pipe thread tapered plug.
On the rear housing since the engine was together, I used high pressure fuel inj. hose and a ~2" long stainless pin that fit snuggly in the hose; clamped it all together w/ fuel inj. clamps (Not worm drive clamps, but the ones that *just* fit the hose and incorporate a captured nut and screw to tighten).
It stood ~4" off the engine and would have looked dorky except I used it as a stand to hold my vacuum lines running through a spark plug wire spacer
On the rear housing since the engine was together, I used high pressure fuel inj. hose and a ~2" long stainless pin that fit snuggly in the hose; clamped it all together w/ fuel inj. clamps (Not worm drive clamps, but the ones that *just* fit the hose and incorporate a captured nut and screw to tighten).
It stood ~4" off the engine and would have looked dorky except I used it as a stand to hold my vacuum lines running through a spark plug wire spacer