Marren Fuel Injectors - only one grommet?
#1
RedDawg_38
Thread Starter
Join Date: Oct 2004
Location: elizabethton, tn
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Marren Fuel Injectors - only one grommet?
I just removed my ORIGINAL 18-year-old fuel injectors and had 'em tested. Bad news--three of them were bad; one was leaking and bad spray pattern on another two, after cleaning.
So, I ordered four new injectors (Part # 0545NAL) from Marren Injectors at http://www.injector.com/fuelinjector...e57629d3091bcf and just got them today.
The Marren injectors are supposed to be drop-in replacements for the originals.
The Marren injectors were delivered with no grommets, so I got on the phone with them and they said they only had one grommet for their injector--the lower one. I don't want to reuse the old grommets because they are 18 years old and hard as a rock, but they won't fit the Marren injectors anyway because the corresponding parts of the injectors are slightly smaller than my original injectors.
FYI, my car is a stock 1986 GXL which I bought new. The original injectors are 450 cc/min. low impedance Denso 1350's. I checked resistance on both the old and new and all measured 3 ohms.
They guy I talked to at Marren seems to think I don't need the upper grommet--which I ain't buyin'.
Does anyone know anything about this? Any and all help greatly appreciated.
So, I ordered four new injectors (Part # 0545NAL) from Marren Injectors at http://www.injector.com/fuelinjector...e57629d3091bcf and just got them today.
The Marren injectors are supposed to be drop-in replacements for the originals.
The Marren injectors were delivered with no grommets, so I got on the phone with them and they said they only had one grommet for their injector--the lower one. I don't want to reuse the old grommets because they are 18 years old and hard as a rock, but they won't fit the Marren injectors anyway because the corresponding parts of the injectors are slightly smaller than my original injectors.
FYI, my car is a stock 1986 GXL which I bought new. The original injectors are 450 cc/min. low impedance Denso 1350's. I checked resistance on both the old and new and all measured 3 ohms.
They guy I talked to at Marren seems to think I don't need the upper grommet--which I ain't buyin'.
Does anyone know anything about this? Any and all help greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM