Machining of H&R spacers.... knowlegable shop needed.
#1
Full Member
Thread Starter
Join Date: Feb 2001
Location: Trenton, NJ
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
Machining of H&R spacers.... knowlegable shop needed.
I want to get my H&R spacers machined to take of about an 1/8 of an inch..... the 25mm spacers with the FD rims are a tad too wide and causes rubbing of the tires. I thought about putting 205's on the front, but i'd rather stick with the 225's. Anyone know of a good place that can machine these? I would imagine the studs would have to be pressed out and back in afterwards...... i don't want a regular machine shop screwing this up.
Thanks,
Matt
Thanks,
Matt
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
joel(PA)
Group Buy & Product Dev. FD RX-7
8
10-04-15 06:07 PM
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM