Low compression?
#1
Junior Member
Thread Starter
Join Date: Jan 2009
Location: Burnaby
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Low compression?
Hi, just wondering if I can get some opinions or advice from anyone about my fc. I tried driving it a few times and never found the tac to pass 4000rpm. Having that said, every time it revs to that point it's super loud. I first thought it was because of a exhaust leak, then I bought a brand new turbo back exhaust system and installed it but it's still the same results. So could low compression and being super loud be that the apex seal is gone? Any professional opinion will be appreciated.
Thanks,
Dom.
Thanks,
Dom.
#5
Full Member
iTrader: (3)
Join Date: Oct 2009
Location: new york
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
LOL I also agree with the guy above, hey Agreen helped me out with a question i made about my compression being really low im going to redo a compression test to make sure i did it properly but would still like to know how bad is 60psi on each chamber for my 89 turbo II?
#6
PedoBear
iTrader: (4)
Seriously ? why can't people get the FSM and read it ?
60 psi at WHAT rpm ? for 100% accurate results, you need to know how far you live above sea level (or at sea level)
your location saids New York, assume u're in NYC, which is pretty close to the sea level, so I need to know what rpm u did ur "test" on to tell if u pass or failed.
But for the record, 85 psi @ 250 rpm is considered normal/typical/ok/pass, and your engine has to be "warmed up/hot" b4 you do the compression test.
60 psi at WHAT rpm ? for 100% accurate results, you need to know how far you live above sea level (or at sea level)
your location saids New York, assume u're in NYC, which is pretty close to the sea level, so I need to know what rpm u did ur "test" on to tell if u pass or failed.
But for the record, 85 psi @ 250 rpm is considered normal/typical/ok/pass, and your engine has to be "warmed up/hot" b4 you do the compression test.
Thread
Thread Starter
Forum
Replies
Last Post
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM