2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

lots of hesitation

Thread Tools
 
Search this Thread
 
Old Dec 6, 2006 | 02:05 PM
  #1  
OGFC's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2006
Posts: 63
Likes: 0
From: Oh
lots of hesitation

ok had a little hesitation yesterday,now today just got a full tank of gas and gas treatment. and im having a butt load of hesitation,barely got it home..idle is good,but when i rev it, it doesnt want to rev.maybe its the injectors,spark plugs? i hope its not running on one rotor or an apex is doneford.any suggestions, flames,bashes,input,help from a rotary man?
Reply
Old Dec 6, 2006 | 02:19 PM
  #2  
jkimbro's Avatar
resU deretsigeR
Tenured Member 15 Years
iTrader: (3)
 
Joined: Aug 2005
Posts: 681
Likes: 0
From: Yep
So, it's worse now....you could have a massive vacuum leak somewhere. But, then again it probably would idle differently. Might pull the plugs...see what that story tells.
Reply
Old Dec 6, 2006 | 02:19 PM
  #3  
OGFC's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2006
Posts: 63
Likes: 0
From: Oh
correction: does not rev at all after 2500RPM
Reply
Old Dec 6, 2006 | 02:21 PM
  #4  
jkimbro's Avatar
resU deretsigeR
Tenured Member 15 Years
iTrader: (3)
 
Joined: Aug 2005
Posts: 681
Likes: 0
From: Yep
Even under partial throttle? Your AFM could be all outta wack....might check it's connections
Reply
Old Dec 6, 2006 | 04:21 PM
  #5  
OGFC's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2006
Posts: 63
Likes: 0
From: Oh
Pulled and cleaned the plugs,seems even weaker now,rev limit at 1500-2000
Is this a sign of crap injectors or time to save up for a turbo II?
Reply
Old Dec 6, 2006 | 05:42 PM
  #6  
OGFC's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2006
Posts: 63
Likes: 0
From: Oh
just tried to start it, it gets enough fuel to start, but cant hold an IDLE.
Possible culprits:Gas treatment f' ed up the injectors? water or antifreeze in the engine? spark plugs?( i did pull and cleaned them,slightly darkened and it ran after i replaced) so i dunno. yall and me, me, me at the bar last nite, my girl and i, me and my car, me on hits, me listening to deathmetal, people that dont want to help, you gfs' thinkin bout me, me right now, me right now, me all the time.
Reply
Old Dec 6, 2006 | 06:24 PM
  #7  
91verty's Avatar
spunout
Tenured Member 05 Years
 
Joined: Dec 2005
Posts: 1,029
Likes: 1
From: Austin
Sounds like it could be the gas treatment you out in did a number or perhaps the thottle positioning sensor.
Reply
Old Dec 6, 2006 | 06:30 PM
  #8  
Mankdrake 2661's Avatar
Mazda goes MMMMMMMM
Tenured Member: 20 Years
iTrader: (8)
 
Joined: Oct 2004
Posts: 1,002
Likes: 1
From: Collinsville, IL
Cat Might be clogged.
I did a super dose of clener once and Killed my catylitic converter.
Reply
Old Dec 6, 2006 | 11:04 PM
  #9  
fc3sna's Avatar
Senior Member
Tenured Member 05 Years
 
Joined: Feb 2005
Posts: 329
Likes: 0
From: Vero Beach, Florida
i had a similar problem it was the anti after burn valve block off plate i put on with out a seal. pretty much a vac leak some where in that area is probly it.
Reply
Old Dec 7, 2006 | 02:37 AM
  #10  
OGFC's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2006
Posts: 63
Likes: 0
From: Oh
update

the car starts good,its idles very good, but wont rev past 1500 seems like a rev limiter.
Reply
Old Dec 7, 2006 | 12:33 PM
  #11  
OGFC's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2006
Posts: 63
Likes: 0
From: Oh
rx7=strange???

So! i started it up this morning let it warm up for like an 45 mins to an hour and it drove and revs very well..is there an explanation for the strange behaviour yesterday?
Reply
Old Dec 7, 2006 | 01:52 PM
  #12  
slpin's Avatar
7th Heaven
Tenured Member: 20 Years
iTrader: (9)
 
Joined: Nov 2004
Posts: 3,663
Likes: 4
From: California
next tiem it does that, disconnect the tps and try again, probably from bad insulation or whatever and crap got into that **** and fucked some things upi
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
Mar 15, 2022 12:04 PM
Bauer778
3rd Generation Specific (1993-2002)
10
Nov 4, 2015 04:42 PM
Feffman
SE RX-7 Forum
1
Oct 7, 2015 06:57 AM




All times are GMT -5. The time now is 09:54 AM.