loose wiring at tps
#1
Full Member
Thread Starter
Join Date: Apr 2006
Location: st. petersburg florida
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
loose wiring at tps
i was setting my tps today and when i went to pull my probes out of the connector my car almost stalled, i had to tap the throttle to keep it running.
I checked where the wires go into the connector (pushing on them and no changes). I slightly wiggled the wire on the tps and back to normal it goes, also i went for a drive and everything was fine untill i step on it and push in the clutch to check the idle and it almost stalled, i did this a few times and sometimes it did it and sometimes it had a solid idle, any ideas, bad tps or bad connector or maybe a ground near there thats loose or something? Any ideas of what i should check, i've seached and nothing on this subject...im out i'll check this thread in the morning to give you guys some time to think, thank you and good night
I checked where the wires go into the connector (pushing on them and no changes). I slightly wiggled the wire on the tps and back to normal it goes, also i went for a drive and everything was fine untill i step on it and push in the clutch to check the idle and it almost stalled, i did this a few times and sometimes it did it and sometimes it had a solid idle, any ideas, bad tps or bad connector or maybe a ground near there thats loose or something? Any ideas of what i should check, i've seached and nothing on this subject...im out i'll check this thread in the morning to give you guys some time to think, thank you and good night
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM