Looking for some help.
#1
Can Post Only in New Member Section
Thread Starter
Looking for some help.
Hey guys I'm having a problem with my 87 turbo 2 its only firing on 3 ports T1 has no spark. I changed the whole trailing coil assembly with a new one(used) but it has the same problem. I'm running a haltek e6k and msd 6a
The following users liked this post:
Speedy87 (10-08-17)
#3
Can Post Only in New Member Section
Thread Starter
so I checked the esm and when I check the br/y wire it stays at 2.4 volts with the engine off and key on. when I turn the crank by hand it doesn't change. my car has a haltech ecu in it and I think the wrong wire might be going to the br/y wire from the haltech or maybe the main relay is no good?
#4
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
Well no offense but if your car has a Haltech I would post in the Haltech section about this problem.
This section is like a General section basically for stock Fc's ..more or less.
You get out of the scope of Stock when you toss in an after market EMS that requires finesse..
It's bad enough that the average guy can't understand the stock system..
This section is like a General section basically for stock Fc's ..more or less.
You get out of the scope of Stock when you toss in an after market EMS that requires finesse..
It's bad enough that the average guy can't understand the stock system..
The following users liked this post:
Speedy87 (10-09-17)