I found the installation instructions on fc3spro and it said "Set numerical thumbwheels to "01" - multi-spark and no rev-limiter."

I assume by the thumb wheel he means to two wheels on the side of the box. By 01 I am also assuming the left wheel is at "0" and right wheel is at "1". Please confirm?

Additionally I'm not sure that's right. "00" looks right to me. NO rev limiter and multispark is active. Please confirm?

For reference Cranes site says

Special switch settings are:
00 Disables the internal rev limiter and allows operation above 9,900 RPM.
01 Disables multiple spark and internal rev limiter.
02 Disables the internal rev limiter and timing retard. Special compatibility mode for external Crane rev limiters and engine controls.
03 Tach test step mode. Causes tach to step from 1,000 to 10,000 RPM in 1,000 RPM increments.
04 Tach test ramp mode. Causes tach to slowly ramp from 200 to 10,000 RPM.
05 Not used.

 

that writeup was probably made 7 or 8 years ago, the product could have changes slightly since then. I remember looking at it not long after I joined rx7club and you've been registered on here longer than me. From what you've posted "00" looks good to me.

 

00. Mine has been set to 00 for the past 11 years.

 

right on. Thanks guys. Hopefully this takes care of the low boost, part throttle hesitation I'm getting as my 1650's come on.