a little assistsnce please
Thread Starter
Junior Member
Joined: Oct 2016
Posts: 22
Likes: 0
From: miami
a little assistsnce please
So i recently got a hold of an adapter plate and s6 UIM, i just need a little help throughout the forum if there has been a write up either using and adapting the s4 tps or integrating the s6 tps. I have an s4 t2. Thank you
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
The s4 is a 3 wire TPS and the FD is a four wire.
Really you only need 3 wires from the FD TPS to hook to the harness.
Look up the FD TPS wiring in the Haltech section..and that should give you the wires that you need to hook up the TPS.
If you take the Mating end off an old S4 TPS and use a Pigtail that goes TO the FD TPS,you can make a patch harness so you can connect the harness to the FD TPS.
Really you only need 3 wires from the FD TPS to hook to the harness.
Look up the FD TPS wiring in the Haltech section..and that should give you the wires that you need to hook up the TPS.
If you take the Mating end off an old S4 TPS and use a Pigtail that goes TO the FD TPS,you can make a patch harness so you can connect the harness to the FD TPS.