knock sensor?
#1
Senior Member
Thread Starter
Join Date: Feb 2005
Location: Orlando
Posts: 391
Likes: 0
Received 0 Likes
on
0 Posts
knock sensor?
i have a 6 port block, and everything else is tII from the turbo to the ecu. i was told i needed to tap a hole for the knock sensor if i was using the tII ecu. then i called mazdatrix and asked them and they said i dont need to use the knock sensor, and that it wont hurt performance at all. is this true?
#2
I'm a boost creep...
Join Date: Jan 2002
Location: Auckland, New Zealand
Posts: 15,608
Likes: 0
Received 8 Likes
on
8 Posts
They're right, you don't need it. Early knock-sensing system were only useful below ~4000rpm anyway, and were mainly to prevent knocking caused by low-rpm lugging. If you drive the car properly the system would most likely never operate anyway.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
83revival
New Member RX-7 Technical
4
09-03-15 10:42 PM