about to do a j-spec swap for my s5 , but i hear i'll have problem's with the wiring anyone have a soluition ?




chris

 

A JSPEC non turbo into a USA non turbo or a Turbo into a non turbo, or?

Either way, use the EM harness that is on your engine presently. Only two wires need attending to if you do it that way.

 

solution: search "haltech" lol

 

Two wires change on your present harness vs a cluster **** of haltah wiring plus the couple of grand to get someone to make it actually Work. Dumb.

 

it's a 91 j-spec turbo ii engine going into a 91 na. the importer said i would have to swap out the whole engine harness, but damn ..lol

 

i was under the impression that there was no NA jdm 13b

 

Ah. So I'm a dunderhead. I'll get over it in the next five minutes.

 

Well, if it comes with a EM harness, it will probably be a JDM harness with all its problems.

You could use your na EM harness on the turbo engine with a few changes. Look at the following thread and the remarks by the fellow who has the word *convertible* in his name. https://www.rx7club.com/forum/showth...5+non+turbo+to

 

thx yall

chris