Inner tie rod boot question
Thread Starter
Full Member
Joined: Jan 2010
Posts: 95
Likes: 0
From: Dallas
Inner tie rod boot question
This is for all the part gurus out there, and anyone who works at a parts counter and might have one to measure.
I recently bought a set of inner tie rod boots from NAPA. The right boot went on just fine and is perfect. The left boot will fit over the inner tie rod, but the large opening will not fit on the rack housing.
The right tie rod boot measures 6.87" long, 1.74" on the large opening and .4" on the small opening. The left measures 6.62" long, 1.42" on the large opening and .36" on the small opening.
Do these measurements match the OEM measurements or is NAPA selling the wrong parts?
I recently bought a set of inner tie rod boots from NAPA. The right boot went on just fine and is perfect. The left boot will fit over the inner tie rod, but the large opening will not fit on the rack housing.
The right tie rod boot measures 6.87" long, 1.74" on the large opening and .4" on the small opening. The left measures 6.62" long, 1.42" on the large opening and .36" on the small opening.
Do these measurements match the OEM measurements or is NAPA selling the wrong parts?
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic S5 Turbo PNP Unit questions
_Tones_
Adaptronic Engine Mgmt - AUS
10
May 25, 2021 05:37 AM
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM
