Whats the resistance needed for the 460cc red-tops off the 86 non-turbo rx7? It's model #195500-1350. The injectors aren't in an rx-7, so any responses concerning the ecu wouldn't really help, its more of a general question. Thanks.

 

2-3ohm

 

thanks... as far as a set of (4) injectors off the 86 non-turbo, two are primary and two are secondary, correct? Which are peak and hold and which are saturated? The whole reason behind all the questions is these are going into a civic (dont kill me for posting here!), I just thought this would be the best place for info. So, is that even possible, or with the secondaries firing past 3800rpm, just not possible to do?

 

Please check the FAQ. Injector part numbers and impedance are covered.

The primary and secondary injectors are just standard units, nothing special about them. All '86 injectors are low impedance. Presumably your Civic require high impedance so you will need series resistors if you have not upgraded to a standalone.

 

lol is that you jr? didn't you stop by my shop the other day?