Injector question (crack)
#1
i am legendary
Thread Starter
Join Date: Sep 2003
Location: Kirkland, WA
Posts: 8,478
Likes: 0
Received 0 Likes
on
0 Posts
Injector question (crack)
Alright I just wanted to make sure about this. When I send out injectors to get cleaned and flowtested and all that, they replace the o-rings and stuff correct? I just got a pair of 550cc TII injectors and one of them has a crack in what I think is the pintle cap? Is that the pintle cap? Will that get replaced when I get them cleaned and tested and all? Or do I have to replace that piece myself? Here's the pic and thanks for any confirmation or help.
#2
Rotary Enthusiast
When my injectors were returned to me from cruzinperformance.com those pieces were replaced. Definately that cracked one was nice a new. Everything I could see was new on the injectors.
#5
Rotary Enthusiast
Rich at Cruzin Performance did a great job, gave me a page to view the flow differences before and after the cleaning. I had them back in my hands 5 days after I sent them out. To me thats great time. He told me how long it would take too. So it may vary for you and of course depending on where you live in comparison to where he's at.
I noticed an improvement on my stock setup, im guessing becuase im sure those injectors I have needed a good cleaning. I have some pictures at home of how the injectors were returned to me. Well packaged and sealed professionally in a little bit plastic. It was very nicely done, I would recommend it to anyone.
I noticed an improvement on my stock setup, im guessing becuase im sure those injectors I have needed a good cleaning. I have some pictures at home of how the injectors were returned to me. Well packaged and sealed professionally in a little bit plastic. It was very nicely done, I would recommend it to anyone.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM