idle mixture sensor
Lives on the Forum
Joined: Feb 2004
Posts: 5,721
Likes: 3
From: Coldspring TX
idle mixture adjustment screw, you mean?...
mounted on the right strut tower, near the boost/ pressure sensor, little round "stub" sticking up with sealant in it so you can't play with it (unless you really want to)
mounted on the right strut tower, near the boost/ pressure sensor, little round "stub" sticking up with sealant in it so you can't play with it (unless you really want to)
HAILERS
Joined: May 2001
Posts: 20,563
Likes: 27
From: FORT WORTH, TEXAS,USA
http://www.teamfc3s.org/forum/showth...threadid=31387
Don't expect yours to come with that small tape measure. That was only supplied on Special Edition 87TurboII's by request.
Don't expect yours to come with that small tape measure. That was only supplied on Special Edition 87TurboII's by request.
HAILERS
Joined: May 2001
Posts: 20,563
Likes: 27
From: FORT WORTH, TEXAS,USA
No you don't need it. The ECU will default to a set setting and the car will run. It's only for idle and idle adjustment. It has a R and a L direction for the screw in that tower outfit. I think the R stands for real lean and the L stands for LOTTSA fuel. Pretty sure about that. Stake my reputation on it.
Thread
Thread Starter
Forum
Replies
Last Post
barkz
Power FC Forum
37
Nov 21, 2020 09:34 AM
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM
The1Sun
1st Generation Specific (1979-1985)
0
Sep 7, 2015 10:21 PM