Hey guys I welded in my seat to the floor and now the check belt light is on. Both work going up and down, everything latches. I am thinking I might have nicked the harness while I got a spot on the inside of the drivers side. At any rate if I take that light out will the ecu throw a check engine light, or should I just sharpie/tape it?

Thank you!

 

The sensor for the seat belt sends a ground to the light to cause it to turn on thus you must have grounded that wire accidentally. You could just remove the bulb and be done with it.

 

Sweet, that is what I was looking for. Thank you!