if i remove the rats nest doesnt that affect the a/c and p/s... if i remember correctly there are plugs that go to them and vaccum lines... i want to remove it but dont want to lose the a/c, and p/s until i get a manual rack.... anybody done this without sacraficing them... and also what page on the fsm is it in... i thought i downloaded the entire thing but apparently im missing a few.. thanks in advance

christopher

 

Uhm, no, you're not right. They'll work just fine without the vac rack.

 

well ok then lol... guess some bad information in the past set me back a bit... ill be doing it this weekend then ... now off to find a good write up.. unless yall post and beat me too it... thanks again

 

Well, assuming you're discussing the 88 'vert in your sig, it's an S4. I have an S4, and the rats nest has nothing to do with the P/S or A/C. My rat's nest is functionally removed (still installed, only because I couldn't find my 7' of fuel injector hose when I was working on it last time - nothing connected though other than fuel), and they both work fine.

-=Russ=-

 

The only thing the rat's nest would affect other than emissions... is on a S5... the VDI and 6 ports' path from the ACV to the actuators maze around in the rat's nest. However... you can just run hose like I do .

 

ok got it ... thanks again... still lookin for info on removing the right stuff