Can someone take a picture of where their stock exhaust system split air tube, on a s4 TurboII connects to on the engine? Please! I took my stock exhaust off so long ago and put on a block off plate that I don't even have a clue what went there or how the split air tube connects to the engine. I still have the egr valve assembly, but right now I have the air pump hooked up to it which I don't know if its correct or not...

But anyway if someone could post a picture of where and how the split air tube is connected to the passenger side of the engine (where I have a block off plate) it would be very appreciated and very helpful!

Thanks

 

I need a close up of what is going in the circled area for a stock setup of exhaust split air tube and air pump connnections, this picture almost does it but not quite.

 

Look for the small block-off plate that you put on the side of the LIM. Surely you don't need a photo for this?

 

Page 1-12, item 16, of the online, free, 88FSM. The ENGINE section. I just looked.

And yet another place is section 4B, the FUEL section. Page 4B-4.

Airpump hooked up to the EGR? That's a hoot.

 

Or I should say I have the air pump tubing hooked up to it as the air pump is not in the car right now. All I did was follow the racing beat instructions to install the race exhaust, but I don't have the instructions anymore.

Yes I know where the block of plate is that I put on the engine, but what used to be there? I don't know.... so I was looking for a picture of the stock setup to look at to see what used to be there and what connects to what used to be there,guess I wasn't too specific.