how do you take off stock turbine housing?
#1
Rotary Freak
Thread Starter
how do you take off stock turbine housing?
i am about to port my wastegate i took off 4 of the 6 screws that hold on the turbine housing 2 are still on there but are loose it's the 2 that get blocked by the oil lines i can't get the casing loose to unscrew them the rest of the way how do i get the casing loose so i can pull it apart
#3
I R SAD PANDA W/O BAW
13mm open wrench and just keep loosening them. The bolts will push the hotside from the center section and you might need a rubber mallet to persuade it a little. You should also mark and/or note the orientation of the hotside so you dont have issues with your downpipe lining up or your wg actuator rod getting kinked.
#4
Rotary Freak
Thread Starter
i used a open end wrench if i use any more force i will strip the bolt i used penetrating lube and hit it with a hammer to try to loosen it but it didnt work
#5
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Have you hit it with a mans hammer, or just a little one? Under the pressure of the bolts and multiple hammer blows, I've never had one not come off. Those bolts will take quite a bit of force before they strip (they're high grade M8s), you can can apply some grunt. Just don't go crazy...
#6
I R SAD PANDA W/O BAW
You could probably also torch it if you are afraid to snap it. I like using mapp gas to heat things up. You might also consider that it may be crossthreaded if there was a chance it was taken apart once before.
Last edited by ilike2eatricers; 06-24-05 at 03:50 PM.
Thread
Thread Starter
Forum
Replies
Last Post
jetlude
Single Turbo RX-7's
4
08-18-15 04:53 PM