im wondering how do you do it im a newb to fc's and still got alot to learn ..... i been asking ... everybody says low brake fluid...wtf ... i know my brake fluid is good i recently serviced my brakes .

 

Adjusting the hand brake is covered in the factory shop manuals. Links for factory shop manuals can be found in the FAQ for FC sticky thread found at the top of this, the 2nd gen RX-7 Technical section.

You can do minor adjustments by removing the hand brake cover and turning the adjustment nut there.

But that will not fix a brake warning light. It will only adjust the cable tightness and how many clicks up you pull on the hand brake to lock it.

 

Did you post because of a warning light, or is there a problem with the operation of the hand brake?

 

He posted the same question in a brake warning light thread, so that is why I referenced it in my reply here in this thread.

 

no brake light i just wanted to adjust it but i dint wanna have to post a NEW thread.... but yea thanxs left of right ?? what makes it tighter ? thanxs
-nukeall-

 

undo the nut from the clip..turn the nut clockwise..if the bottom cable part,with the thread going into the nut is coming up to protrude from the top of the nut..then you are tightening the E-Brake cable..The Handle should be able to click at Least(minimum)2-3 clicks..any less the Cable is most likely too tight and the E-Brake will drag the pads..

 

thanxs dude .... thanxs